Dualsky ECO 2316C V2, 980KV

RPM / Volt: 980KV
Antal celler: 3 til 4 Li-Po
Propel 3s: 10x5 til 11x7
Propel 4s: 8x6 til 9x6
Maks. strøm: 25 Amp. / 10 sek.
Diameter: 28,8 mm
Aksel diameter: 3,17 mm
Vægt: 72 gram

Features of ECO V2 motors:

• 25% stronger structure compared to the ECO series while maintaining the same weight
• engine life increased by 50% compared to the previous ECO series
• reinforced axles
• Dynamically balanced rotor
• optimized heat dissipation
• waterproof stator - ready for operation in rain and moisture - NOTE the bearings are not waterproof!
• NEW LABELING RULES based on stator diameter and length and KV (revolutions per volt of no load voltage)
• a wide range of models in the most popular sizes up to a power of over 2000W and optimally matched KV parameters
• standard-length wiring with factory-soldered connectors (connector sockets for soldering on the controller cables are included in the set)
• motor shaft protruding on the stator side
• reverse mounting possible, hub for screwing onto the rotor is included
• Mounting cross and screws are included
• Aluminum alloy motor housing, CNC machined and anodized
• NMB bearings
• N4SH magnets
• the model markings are laser etched on the rotor thus eliminating any impact on the balance
• a product aimed at intermediate pilots of airplanes and multicopters, guaranteeing high quality with a low purchase cost
• product packed in an aesthetic box

Basic technical data:

• dimensions: 28.8 x 32.9mm
• axle diameter: 3.175 mm
• distance between fastening screws: 16/16 mm
• power supply: 3-4 Li-pol cells
• weight (without cables): 72 g
• KV: 980 rpm
• recommended propellers: 3S: 10x5, 11x7 / 4S: 8x6, 9x6
   
• highest efficiency under load: 15A
• maximum instantaneous load: 25A (up to 15 seconds)
• maximum power (15 seconds): 300W
• no load current consumption (10V): 0.7A
• internal resistance: 80.4 mOhm
• recommended regulator: 30-45A e.g. Dualsky XC-45-Lite
• application: aircraft models weighing 600-1400g
• set includes: crosspiece for mounting, propeller hub for reverse assembly, male connectors DB3 3.5 mm soldered on the cables + connector sockets and heat-shrinkable tubes